Dress-Up Elements

	*Dress-up commands are documented in the Interactive Drafting user's guide. As such, the information detailed in this section is presented in an Interactive Drafting context.*
	Still, you can open the GenDrafting_part.CATDrawing document and thus manipulate annotations and dress-up elements in a Generative Drafting context.
	This dress-up will be associative to the elements created from a part or an assembly. When created, these elements are associated with a view.
	Note that if you delete generated center lines, threads or axis lines, you will NOT be able to generate them again (by updating the drawing). It is impossible to restore generated center lines, threads or axis lines that have been deleted.
	Create center lines (no reference): Apply a center line to one or more circles.
	Create center lines (reference): Apply a center line to one or more circles with respect to a reference (linear or circular).
	Modify center lines: Modify one or more center lines at one or more end(s) of this/these center lines.
	Create threads (no reference): Create a thread without a reference.
	Create threads (reference): Create a thread with a reference, either circular (circle or point) or linear (line).
	Create axis lines: Create an axis line by selecting lines.
	Create axis lines and center lines: Create an axis line by selecting lines.
	Create an area-fill: Create an area fill, i.e. a closed area on which you will then apply graphical dress-up elements called patterns (these can be hatching, dotting or coloring). Patterns can be applied to area fills created from both sketched and generated elements.
	Create arrows: Create an arrow.